Table of Contents
Advertisement
Barrier Screen Visual Deflector Adjustment
The barrier screen assembly has an adjustable visual deflector along the lower edge. If the assembly is adjusted
to accommodate thick facing material, adjust the deflector, as shown below, to block the view of the valve area.
1. Place the screen assembly face down on a soft surface to protect it from scratching. Locate the nuts
along the bottom edge of the deflector (in this example there are 3, your fireplace may have more).
2. Remove the nuts using an 11/32" nut driver. Move the deflector to the desired position and reinstall the
kept nuts. Test fit the assembly to the fireplace and make any adjustments as needed.
© Travis Industries
Installation
(for qualified installers only)
6/3/19 - 1453
53
PB 42 & 54 MV/GSB2 Install
Advertisement
Table of Contents
