Table of Contents
Advertisement
42
Screen Assembly Mounts
The screen assembly mounts (located on outer front edges of the fireplace) are adjustable to allow the screen
assembly to be positioned 1/2" (12mm) to 1-/12" (38mm) from the front of the fireplace. This allows facing to tuck
under the screen assembly. Each mount is held in place by (3) Philips head screws. Before mounting the screen
assembly, adjust the mounts so that the front edge is flush with the finish material surrounding the fireplace. To
adjust the mounts, loosen the screws, slide the mounts to the desired position, then tighten the screws.
Screen assembly mount
may be slid forward to
accommodate facing.
© Travis Industries
Installation
(for qualified installers only)
Thin Facing (1/2" 13mm) - Top View
Phillips
Screwdriver
Thick Facing (1" 26mm) - Top View
Fireplace
Screen Assembly
Mount
Fireplace
Screen Assembly
Mount
6/3/19 - 1453
Position edge of mount
flush with finish material
Framing
Drywall
Max. 1/2" (13mm) Overlap
Framing
Drywall
Max. 1/2" (13mm) Overlap
PB 42 & 54 MV/GSB2 Install
Advertisement
Table of Contents
