Table of Contents
Advertisement
3-1-4. Forced Version Update
If the version of program or data cannot be updated from the SOFTWARE PACKAGE page of the SERVICE menu, the software or
PLD data version can be updated by the "forced version update".
Tip
The USB connector for connection to a USB drive is located to the lower right of the front panel.
Forced Version Upgrade of Software or PLD Data
Equipment Required
•
USB drive (commercially available)
Tip
For recommended USB drive, contact your local Sony Sales Office/Service Center.
Preparation
Copy the PLD update data to the USB drive using the following procedure.
Note
For how to obtain the data files for update, contact your local Sony Sales Office/Service Center.
1.
Create the following directory in the USB drive.
\MSSONY\PRO\CAMERA\HDCETX50
2.
Copy the data file for update to be updated to the directory created.
Note
Do not copy software or PLD data that is not to be updated.
Procedure
1.
Connect the USB drive that contains the program for update to the USB connector of this unit.
2.
In the MENU control block on the front panel, turn the DISP/MENU lever to the MENU side, and turn the CANCEL/ENTER
lever to the CANCEL side.
3.
While pressing the control knob, turn on the power of the unit.
Each data file for update copied in the USB drive is updated.
Upon completion of the version update, a message "UPDATE SUCCEEDED" appears.
Tip
The version update progress status is displayed on the monitor.
4.
Turn off and on the power of the unit and confirm that the version has been updated on the VERSION1, VERSION2 page of the
DIAGNOSIS menu.
69
Advertisement
Table of Contents
