Table of Contents
Advertisement
2-13. Power Block
Tip
The following part cannot be reused. When replacing the power block.
•
Power duct sheet
Preparation
1.
Remove the top cover. (Refer to "2-2. Top Cover".)
2.
Remove the NET-37 board assembly. (Refer to "2-3. NET-37 Board Assembly".)
3.
Remove the front panel assembly. (Refer to "2-4. Front Panel Assembly".)
4.
Remove the VIF-82 board assembly. (Refer to "2-5. VIF-82 Board Assembly".)
5.
Remove the optical multi fiber cable. (Refer to "2-7. Optical Multi Fiber Cables".)
6.
Remove the CN-4132 board. (Refer to "2-8. CN-4132 Board".)
7.
Remove the DC fan subassembly. (Refer to "2-9. DC Fan (60 x 15)".)
Procedure
1.
Disconnect the harness from the connector (CN102) on the PS-939 board.
2.
Disconnect the harness from the connector (CN5006) on the RE-345 board.
CN5006
(RE-345 board)
PS-939 board
CN102
Harness
Rear side
Harness
60
Advertisement
Table of Contents
