Table of Contents
Advertisement
2-4-1. LE-436 Board
Preparation
1.
Remove the top cover. (Refer to "2-2. Top Cover".)
2.
Remove the NET-37 board assembly. (Refer to "2-3. NET-37 Board Assembly".)
3.
Remove the front panel assembly. (Refer to "2-4. Front Panel Assembly".)
Procedure
1.
Disconnect the two harnesses from the connectors (CN001, CN002) on the LE-436 board.
2.
Remove the four screws, and then remove the LE-436 board.
PSW
3 x 8
Harness
CN001
LE-436 board
Note
At the time of the installation, pass the harness (A) along the inside of the front panel.
3.
Install the removed parts by reversing the steps of removal.
CN002
Harness (A)
Arrangement of the harness
Harness (A)
Filter
Front panel
31
Advertisement
Table of Contents
