Table of Contents
Advertisement
4.
Disconnect the harness from the connector (CN5004) on the RE-345 board.
5.
Remove the four screws, and then remove the LEMO connector assembly
6.
Remove the four screws, and then remove the lug terminal and LEMO CN bracket.
LEMO CN bracket
PSW
3 x 8
Red mark
LEMO connector
assembly
PSW
3 x 8
Note
•
When attaching the LEMO connector assembly, install it with the red mark up.
•
When attaching the LEMO connector assembly, secure the connector assembly temporarily using the four screws, then fully
tighten them.
7.
Install the removed parts by reversing the steps of removal.
Rear panel assembly
PSW
3 x 8
Harness
CN5004
Lug terminal
RE-345 board
Front side
49
Advertisement
Table of Contents
