Table of Contents
Advertisement
3.
Remove the five screws.
4.
Remove the NET-37 board in the direction of the arrow [A].
(b)
NET-37 board
Note
•
If the radiation sheet (2 (35 x 35)) is removed, attach it at the position as shown in the figure.
•
At the time of the installation, insert the two connectors into the two holes.
•
At the time of the installation, tighten the screws in the following sequence: (a), (b), others.
5.
Install the removed parts by reversing the steps of removal.
PSW
3 x 8
Attaching position of the radiation sheet (2(35 x 35))
Scribe lines
NET heat sink A
(a)
Connectors
Holes
[A]
Radiation sheet (2(35 x 35))
NET heat sink A
Radiation sheet (2(35 x 35))
29
Advertisement
Table of Contents
