Set Running Direction Open (White Section) - AUMA SQ 05.2 Operating Instructions Manual

2. If you override the tripping point inadvertently: Move valve in opposite direction
and approach intermediate position again in direction CLOSE (always approach
the intermediate position in the same direction as in later electrical operation).
3. Press down and turn setting spindle [1] with screwdriver in direction of the arrow
and observe the pointer [2]: While a ratchet click is felt and heard, the pointer [2]
moves 90° every time.
4. As soon as the pointer [2] is 90° from mark [3]: Continue turning slowly.
5. As soon as the pointer [2] moves to mark [3]: Stop turning and release setting
spindle.
ð The intermediate position setting in running direction CLOSE is complete.
6. If you override the tripping point inadvertently (ratchet click is heard after the
pointer has snapped): Continue turning the setting spindle in the same direction
and repeat setting process.

11.4.2 Set running direction OPEN (white section)

How to proceed 1. Move valve in direction OPEN to desired intermediate position.
2. If you override the tripping point inadvertently: Move valve in opposite direction
and approach intermediate position again in direction OPEN (always approach the
intermediate position in the same direction as in later electrical operation).
3. Press down and turn setting spindle [4] with screwdriver in direction of the arrow
and observe the pointer [5]: While a ratchet click is felt and heard, the pointer [5]
moves 90° every time.
4. As soon as the pointer [5] is 90° from mark [6]: Continue turning slowly.
5. As soon as the pointer [5] moves to mark [6]: Stop turning and release setting
spindle.
ð The intermediate position setting in running direction OPEN is complete.
6. If you override the tripping point inadvertently (ratchet click is heard after the
pointer has snapped): Continue turning the setting spindle in the same direction
and repeat setting process.
Commissioning (optional equipment settings)
39