Returning To The Service Provider - Acom 06AT User Manual

8.4.4. Returning to the Service Provider

This document section contains the general information on packing and shipping an antenna tuner for
diagnostics and repair.
Should it be necessary to ship the antenna tuner, use the original packing as described
below.
Before shipping the antenna tuner, you should contact your local dealer first.
Your dealer can have a specific shipment requirement, e.g., a different shipping address.
It is the sole customer's responsibility to ensure the antenna tuner is properly packaged
to avoid any shipping damage.
Prepare the antenna tuner for shipping as described below:
Switch off the amplifier via Main Power Switch (see amplifier's User's Manual).
•
Make sure the Main Power Switch is in OFF position;
Pull the amplifier's line (mains) plug out of the outlet;
•
Do not disconnect GROUND connection on the antenna tuner;
•
Disconnect all antenna cables from the rear panel of the antenna tuner (see
•
rear view with connectors
Disconnect cable labeled 50Ω RF +26 VDC POWER & CONTROL from the rear panel of the
•
antenna tuner (see
Remove the GROUND connection last (see
Pos. 1) and wait 30 minutes for safety.
Pack the antenna tuner in its original cardboard carton. Please, follow the instructions in section
•
2.1 Unpacking and Initial Inspection
Seal the antenna tuner carton with heavy duty, 2-inch-wide self-adhesive tape;
•
Finally, the external strapping needs to be added over the antenna tuner carton. Either plastic
•
or metal bands can be used;
Now, the antenna tuner is ready for shipment.
•
Page 62 of 70 | S e c t i o n SPECIFICATIONS
User's Manual | ACOM 06AT | Automatic Antenna Tuner and Switch
NOTICE
NOTICE
, Pos. 2);
Figure 2-4 | Tuner rear view with connectors
DANGER
Figure 2-4 | Tuner rear view with connectors
but in reverse order;
Figure 2-4 | Tuner
, Pos. 3);
,
October 2022