Table of Contents
Advertisement
User's Manual | ACOM 06AT | Automatic Antenna Tuner and Switch
- ERASE ALL TUNING SETTINGS w/o names neither assignments - erases all tune settings from the
tuner memory, and also resets the working hour count, but leaves the antenna names and
assignments unchanged in the amplifier memory.
6.2.4. Erasing the Whole NON-Volatile Memory
ERASE WHOLE N.V. MEMORY - erases the whole tuner memory, resets the working hour count, and also
erases the antenna names and assignments from the amplifier memory.
6.2.5. Checking the Resource Used for the Current Tuning
L-C RESOURCE USED (current tuning) - reads the percentage of coils and capacitors used for the current
tuning (see Section
6.3 Overview of TUNING SETTINGS and Resources Used
6.2.6. Dumping the NON-Volatile Memory in a File on a PC
This function allows backup of antenna assignments by band and antenna names, as well as all user tune-ups
from the non-volatile memories of the tuner and amplifier in a computer file. The tuner data will pass through
the amplifier and be available at its serial (RS-232) port to a computer. Please, use the "ACOM Terminal S"
software, distributed by ACOM free of charge, for the dump. Downloaded backup files can be stored and
used later to restore tuning settings and antenna assignments / names you made for various antenna
configurations (see Section
).
File
The ACOM 06AT tuning-memory DUMP/LOAD procedures are initiated ONLY from the
amplifier "ATU Service" menu and NOT from the "ACOM Terminal S" program (see
6-1 | ACOM Terminal S screenshot
Do not use the Firmware Update button for tuning memory DUMP as the AMPLIFIER
Firmware Update procedure will be initiated instead (see the amplifier manual).
Do NOT change the order of the steps in the following procedures.
October 2022
6.2.7 Restoring (Loading) the NON-Volatile Memory from a File - Memory Load from
NOTICE
.
S e c t i o n ADVANCED FUNCTIONS AND OPTIONS | Page 41 of 70
).
Figure
Advertisement
Table of Contents
