Table of Contents
Advertisement
6.1.3. Editing Antenna Names
At the leftmost part of the table row, below the number of each antenna, there is a text field for its associated
name (set to **No name** by default). You can enter any text, in free format, up to 12 characters. The name
of the currently connected antenna will appear on the main screen, to the right of the numerical boundaries
of the frequency segment.
The selected position of the name character to be edited is highlighted by a small square frame, which can
be moved within the name area using the buttons
the
EDIT or EDIT
buttons, causing all printable characters of the basic ASCII table to appear (there is a
REPEAT function - just hold the button). The antenna name content or meaning does not affect the operation
of the tuner or amplifier.
6.2. Maintenance Functions - ATU SERVICE Menu
In the MAIN menu you can select the row ATU SERVICE using the
selected function with the SELECT
To avoid accidental activation, if you want to intentionally erase the memory, you should press the two
SELECT
buttons simultaneously, and hold them for 2 seconds. Deletion can still be cancelled by pressing
the right arrow key.
6.2.1. ATU Individual Data
The screen displays information about: model (04AT), hardware version (HW Ver: ...) and firmware version
(FW Ver: ...) of the Control board of the tuner and the number of working hours - the hours, during which the
tuner was powered up (Working hours: nnn h).
Please note that "Model" info will be shown as "04AT". This is normal. Both ACOM tuner
models 04AT and 06AT use the same Control board.
6.2.2. ATU Status
When you select the ATU STATUS function, the tuner returns the tuning mode information (ATU matched,
Memory settings, ATU in bypass), the currently connected antenna number, and the boundaries of the
current frequency segment.
6.2.3. Deletion of Individual or Group of Stored Tuning settings
- ERASE CURRENT TUNING - erases the tune settings of the current frequency segment from the
tuner memory;
- ERASE TUNING SETTINGS FOR: [ANTn] - erases the tune settings for all frequency segments of
antenna "n" from the tuner memory;
Page 40 of 70 | S e c t i o n ADVANCED FUNCTIONS AND OPTIONS
User's Manual | ACOM 06AT | Automatic Antenna Tuner and Switch
ITEM or ITEM . Replacing the character is done with
button. You can leave the function by pressing the
ITEM or ITEM
buttons, and activate
SELECT button.
October 2022
Advertisement
Table of Contents
