Table of Contents
Advertisement
User's Manual | ACOM 06AT | Automatic Antenna Tuner and Switch
3.2. Indication, controls and menus
3.2.1. Tuner Information Area on the Amplifier Screen
After the operator specifies in the USER PREFERENCES that a tuner is installed, the amplifier indication
changes:
Figure 3-1 | ACOM 700S amplifier screen with tuner installed
Figure 3-1 | ACOM 700S amplifier screen with tuner installed
- The screen displays a frequency range showing the availability or absence of tuner settings for all
frequency segments in the current band, to which the amplifier is tuned. The light gray segments have a user
tuning stored in the tuner memory, and the black segments do not have one. The current operating segment,
which contains the working frequency of the transceiver, is enclosed in a thin orange frame, which moves as
the transceiver frequency moves from segment to segment.
- The numerical values displayed above the frequency range now show the boundaries of the
current operating frequency segment (rather than of the entire band, if no tuner is present). In front of the
values, there is a label reading "ATU Matched", "Memory Settings" or "ATU in Bypass", according to the tuner
mode at that time. After the values are displayed the number, the selectivity type and the name of the
currently connected antenna (see Section
antenna Nr. 2 with Regular degree of selectivity is selected. The antenna number may be from 1 to 4 and
each antenna may have different type, specified by the operator (up to four degrees of selectivity). The
antenna names after the number may also be edited (see Section
October 2022
6.1 ANTENNA ASSIGNMENT Menu
). For example, "A2R" indicates the
6.1 ANTENNA ASSIGNMENT Menu
S e c t i o n GETTING STARTED | Page 27 of 70
).
Advertisement
Table of Contents
