Table of Contents
Advertisement
User's Manual | ACOM 06AT | Automatic Antenna Tuner and Switch
2.2. Tuner Location Selection
ACOM 06AT tuner is designed for indoor use only!
The unit's weight is about 4 kg and can be handled by a single person.
Position the tuner where it will be used. You will need an easy access to the LED indicator on the front panel,
as well as to the rear panel cabling.
Alternatively, the tuner can be located up to 100 m (330 ft) away from the shack (in another room, but not
outdoor).
Figure 2-3 | ACOM 06AT antenna tuner and switch (shown near 700S amplifier)
Figure 2-3 | ACOM 06AT antenna tuner and switch (shown near 700S amplifier)
2.3. Power Supply Voltage
The tuner is powered by direct-current voltage +26 VDC +10/-15%, supplied through the coaxial cable from
the ACOM amplifier RF OUTPUT to the RF input of the tuner, labeled 50Ω RF +26 VDC POWER & CONTROL.
To avoid any damage (not covered by the warranty), never connect the input jack of the
tuner, labeled 50Ω RF +26 VDC POWER & CONTROL to any power source except the
output of an amplifier from the ACOM transistor series.
October 2022
NOTICE
CAUTION
NOTICE
S e c t i o n INSTALLATION | Page 21 of 70
Advertisement
Table of Contents
