Installation And Connections; Figure 2-4 | Tuner Rear View With Connectors - Acom 06AT User Manual

2.4. Installation and Connections

Position the tuner where it will be used and place it on the desk with the connectors facing to the back. You
will need an easy access to the rear panel cabling.
2
For INDOOR tuner operation, the grounding terminal of the tuner labeled GROUND and
the antenna feeders should be connected as described in Section
To avoid any damage (not covered by the warranty), never connect or disconnect cables
while power is applied at either end of the cable.
Hot-plugging is technically incorrect and is a bad practice to connect or disconnect any
piece of equipment while it is powered on. Make sure the device is switched off before
connecting or disconnecting any cable.
When you use ACOM 06AT with ACOM 2020S amplifier do not use antennas with SWR
above 2.5! Always observe section
Check if the antenna cables and grounding system of your radio station are installed as described in Section
1.6.1 Lightning protection
Page 22 of 70 | S e c t i o n INSTALLATION

Figure 2-4 | Tuner rear view with connectors

Figure 2-4 | Tuner rear view with connectors
8.1.3 Maximum Allowed Input Power
.
User's Manual | ACOM 06AT | Automatic Antenna Tuner and Switch
DANGER
NOTICE
NOTICE
1.6.1 Lightning protection
!
October 2022
3
1
.