Table of Contents
Advertisement
6.2.4. Erasing the Whole NON-Volatile Memory
ERASE WHOLE N.V. MEMORY - erases the whole tuner memory, resets the working hour count, and also
erases the antenna names and assignments from the amplifier memory.
6.2.5. Checking the Resource Used for the Current Tuning
L-C RESOURCE USED (current tuning) - the percentage of coils and capacitors used for the current tuning (see
Section
6.3 Overview of TUNING SETTINGS and Resources Used
6.2.6. Dumping the NON-Volatile Memory in a File on a PC
This function allows backup of antenna assignments by band and antenna names, as well as all user tune-ups
from the non-volatile memories of the tuner and amplifier in a computer file. The tuner data will pass through
the amplifier and be available at its serial (RS-232) port to a computer. Please, use the "ACOM Terminal S"
software, distributed by ACOM free of charge, for the dump. Downloaded backup files can be stored and
used later to restore tuning settings and antenna assignments/names you made for various antenna
configurations (see Section
).
File
The ACOM 04AT tuning-memory DUMP/LOAD procedures are initiated ONLY from the
amplifier "ATU Service" menu and NOT from the "ACOM Terminal S" program (see
6-1 | ACOM Terminal S screenshot
Do not use the Firmware Update button for tuning memory DUMP as the AMPLIFIER
Firmware Update procedure will be initiated instead (see the amplifier User's Manual).
Do NOT change the order of the steps in the following procedures.
Connection Settings (bitrate, port selection, etc.)
Disconnect
Firmware Update
Connect
Page 58 of 88 | S e c t i o n ADVANCED FUNCTIONS AND OPTIONS
User's Manual | ACOM 04AT | Remote Automatic Antenna Tuner and Switch
6.2.7 Restoring (Loading) the NON-Volatile Memory from a File - Memory Load from
NOTICE
).
Figure 6-1 | ACOM Terminal S screenshot
Figure 6-1 | ACOM Terminal S screenshot
).
Figure
October 2023
Advertisement
Table of Contents
