Table of Contents
Advertisement
The amplifier will assign the connected tuner and will then start taking care of its control and indications. At
the assignment and at any subsequent turning on, the tuner will perform a quick tuning to retrieve from its
memory the last saved tuning for the current frequency of the amplifier.
The tuner is also turned off together with the amplifier. Thus, the four antennas are automatically turned off
and grounded. There is no need to assign the tuner from the menu at any subsequent powering on/off. The
amplifier will remember the tuner is installed and will continue to take care of it.
If, for any reason, you decide to operate the amplifier without the tuner, enter the USER PREFERENCES menu
again and select:
After unassigning the tuner, you will have to connect a matched antenna operating at the respective
frequencies to the amplifier output. Also, when the tuner is unassigned, you will not be able to use its antenna
switch.
3.2. Indication, controls and menus
3.2.1. Tuner Information Area on the Amplifier Screen
After the operator specifies in the USER PREFERENCES that a tuner is installed, the amplifier indication
changes:
Figure 3-1 | ACOM 700S amplifier screen with tuner installed
Figure 3-1 | ACOM 700S amplifier screen with tuner installed
Page 44 of 88 | S e c t i o n GETTING STARTED
User's Manual | ACOM 04AT | Remote Automatic Antenna Tuner and Switch
ANTENNA TUNER / SWITCH INSTALLED: [NO].
October 2023
Advertisement
Table of Contents
