A
12. Store the board in an antistatic protective wrapper.
13. Install an expansion slot cover over the vacated slot by aligning the cover with the slot from the
rear of the chassis and pressing the cover into the slot. If you are installing a new board, begin
with step 5 in Installing Hot-plug PCI Add-in Cards below.
14. Close the chassis top cover.
15. If the system is installed in a rack, push the system back into the cabinet rack.
MAXDATA PLATINUM 90004R Server System
Figure 66. Removing a Hot-plug PCI Add-in Card
B
C
OM12951
143