Enable Paging; Page Blackout Interval; Call Retry Interval; Page Destination Configuration View - MAXDATA PLATINUM 9000-4R Product Manual

Figure 52. Page Destination Configuration View
To configure or modify the settings for a page destination, you should select a radio button next to
the desired entry and then click the Edit button. The view displayed then is described in the next
section.
Settings shown on this view that apply to all page destinations are described in the following
sections.

Enable Paging

This checkbox enables paging for the serial/modem channel.

Page Blackout Interval

The Page Blackout Intervals determines the minimum number of minutes between successive pages.
It provides a mechanism to prevent someone from getting back-to-back pages if a flurry of events
occurs. This parameter is entered in minutes and a value of "0" indicates no blackout. The value
entered must be in the range 0-255.

Call Retry Interval

This setting gives the number of seconds between call retries when a busy signal is detected. The
value entered must be in the range 0-255.
MAXDATA PLATINUM 90004R Server System 103