Setting Custom Defaults - Honeywell Voyager 1602g User Manual

Setting Custom Defaults

You have the ability to create a set of menu commands as your own, custom
defaults. To do so, scan the Set Custom Defaults barcode below before scanning
the menu commands for your custom defaults. If a menu command requires scan-
ning numeric codes from the back cover, then a Save code, that entire sequence
will be saved to your custom defaults. When you have entered all the commands
you want to save for your custom defaults, scan the Save Custom Defaults bar-
code.
Note: The Custom Defaults settings apply to all workgroups Scanning the Save Defaults
barcode also causes both the scanner and the host to perform a reset and become
unlinked. You must relink (pair) the scanner to the host. See
Operation
You may have a series of custom settings and want to correct a single setting. To do
so, just scan the new setting to overwrite the old one. For example, if you had previ-
ously saved the setting for Beeper Volume at Low to your custom defaults, and
decide you want the beeper volume set to High, just scan the Set Custom Defaults
barcode, then scan the Beeper Volume High menu code, and then Save Custom
Defaults. The rest of the custom defaults will remain, but the beeper volume set-
ting will be updated.
Voyager 1602g User Guide
Set Custom Defaults
beginning on page 37 for additional information.
Save Custom Defaults
Wireless System
7