Application Plug-Ins (Apps); Ezconfig-Scanning Introduction; Configure With Ezconfig For Scanning - Honeywell Voyager 1602g User Manual

Application Plug-Ins (Apps)

Any apps that you are using can be turned off or on by scanning the following bar-
codes. Apps are stored in groups: Decoding, and Formatting. You can enable and
disable these groups of apps by scanning that group's On or Off barcode below.
You can also scan the List Apps barcode to output a list of all your apps.
Note: You must reset your device in order for the apps setting to take effect.

EZConfig-Scanning Introduction

EZConfig for Scanning provides a wide range of PC-based programming functions
that can be performed on the scanner connected to your PC. EZConfig for Scan-
ning allows you to download upgrades to the scanner's firmware, change pro-
grammed parameters, and create and print programming barcodes. Using
EZConfig for Scanning, you can even save/open the programming parameters.
This saved file can be e-mailed or, if required, you can create a single barcode that
contains all the customized programming parameters and mail or fax that barcode
to any location. Users in other locations can scan the barcode to load in the cus-
tomized programming.

Configure with EZConfig for Scanning

Use the EZConfig for Scanning tool to configure your scanner online:
Voyager 1602g User Guide
* Decoding Apps On
* Formatting Apps On
List Apps
Decoding Apps Off
Formatting Apps Off
173