RS485 Packet Mode
The following selection allows you to break up large barcode data into smaller
packets on an IBM POS terminal. To break up large barcodes into small packets,
scan the Packet Mode On barcode below. Scan the Packet Mode Off barcode if
you want large barcode data to be sent to the host in a single chunk. Default =
Packet Mode Off.
RS485 Packet Length
If you are using Packet mode, you can specify the size of the data "packet" that is
sent to the host. Scan the Packet Length barcode, then the packet size (from 20 -
256) from the
USB IBM SurePos
Scan one of the following "Plug and Play" codes to program the scanner for an IBM
SurePos (USB handheld scanner) or IBM SurePos (USB tabletop scanner)
interface. This interface is only appropriate for an Access Point.
Note: After scanning one of these codes, you must power cycle the cash register.
Voyager 1602g User Guide
* Packet Mode Off
Programming
USB IBM SurePos
(USB Handheld Scanner)
Interface
Chart, then Save. Default = 40.
Packet Length
Packet Mode On
USB IBM SurePos
(USB Tabletop Scanner)
Interface
23