Gas Specifications - Beef Eater 1500 Series Assembly And Operating Instructions Manual

GAS SPECIFICATIONS

NOTES:
• This appliance MUST be installed and serviced only
by a qualified licensed person.
• This product is intended for outdoor use only.
Connecting the appliance to an LPG gas supply
This barbecue is set up for LPG gas and is labelled
accordingly.
The appliance may be supplied LPG from either
• A 9kg portable cylinder, or
• A remote supply of via fixed pipe work.
10
GAS SPECIFICATIONS
Connecting the appliance to a LPG gas cylinder
• The appliance has a 9kg gas bottle regulator and hose
already fitted.
• Connect the fitting of the inlet of the regulator to the
valve on the LPG cylinder.
• Carry out a leakage check.
Gas bottle safety information
• This appliance, when connected directly to an LPG
cylinder, the cylinder capacity shall be 9kg(20lbs).
• The gas cylinder must be made and marked in
accordance with specifications for LPG cylinders.
• It is recommended to turn off the cylinder valve when
the appliance is not in use.
• Gas cylinders must be stored in an approved housing out
of reach of children.
• When disconnecting the gas bottle ensure that all the
control valves are in the 'OFF' position.
• Remove the bottle from any housing in which it may be
stored before disconnection.
• When reconnecting the hose to the bottle, ensure that
all connections are tight before replacing in the storage
compartment.
• Carry out a leakage check. (See leak test procedure on
page 13).
Connecting to a remote supply of LPG
• The appliance shall be installed in accordance with local
authority and any relevant statutory regulations.
Appliance pipe
• Remove the gas bottle hose and regulator from the
Gas connection
appliance pipe.
3/8" SAE Flare
• Connect the consumer supplied fixed LPG pipework to
with 5/8-18
the appliance pipe.
UNF thread
• Carry out a leakage check on all connections.
Fitted LPG gas
bottle hose &
regulator