8.3
Troubleshooting
If faults are detected on or in the device, these are indicated by the LEDs with the appropriate
message. If a reset of the device is required due to the fault, the pending fault must first be
eliminated and acknowledged by closing inputs X3-X2 (reset).
In the case of system faults, the device must be briefly switched off. If a system fault is
detected again on switching on, the device must be returned to the manufacturer.
3TK2810-0 standstill monitor
Equipment Manual, 08/2023, A5E50307927002A/RS-AA/001
Diagnostics
8.3 Troubleshooting
57