Transportation, Storage And Disposal - Husqvarna BMS 280P Operator's Manual

Error code number
0131
0337
0351
0352
61
Transportation
WARNING:
transportation. The product is heavy and can
cause injury or damage if it falls or moves
during transportation.
WARNING:
transportation of the product.
CAUTION:
behind a vehicle.
• Lift the product or use a front wheel dolly (optional
accessory) to move it shorter distances. Refer to
Accessories on page 26 .
• For longer distances, put the product on a
transportation vehicle.
• Put some type of protection on the product
during transportation. The protection keeps natural
elements such as rain and snow away from the
product.
To move the product up and down a
ramp
WARNING:
move the product up and down ramps. The
product is heavy and there is a risk of injury
if the product falls or moves too quickly.
22
Cause
The oxygen sensor has an open connec-
tion, broken wire or faulty sensor.
The crankshaft position sensor has no sig-
nal due to air gap incorrect, loose sensor,
open or shorted connection or faulty sen-
sor.
The cylinder 1 Ignition coil Malfunction
due to broken wire in harness (may not
be visible), shorted connection or faulty
sensor.
The cylinder 2 ignition coil malfunction
due to broken wire in harness (may not
be visible), shorted connection or faulty
sensor.
End of code transmission.

Transportation, storage and disposal

Be careful during
Remove the tool before
Do not tow the product
Be very careful when you
Solution
Consult the service manual of the engine
and speak to Husqvarna servicing dealer.
Consult the service manual of the engine
and speak to Husqvarna servicing dealer.
Consult the service manual of the engine
and speak to Husqvarna servicing dealer.
Consult the service manual of the engine
and speak to Husqvarna servicing dealer.
WARNING:
slope, always use a winch. Do not walk or
stay below or near the product.
• To move the product down a ramp, operate the
product forward slowly.
• To move the product up a ramp, operate the product
rearward slowly.
• Do not turn the product to the left or to the right more
than 45° on a ramp.
To lift the product
WARNING:
equipment has the correct specification to
lift the product safely. The type plate on the
product shows the product weight.
WARNING:
or near a lifted product. Keep bystanders
away from the risk area. Refer to
safety on page 8 .
WARNING:
product. Make sure that the lifting eyes are
correctly installed and not damaged.
1. Remove the tool.
For ramps with a steep
Make sure that the lifting
Do not walk or stay below
Work area
Do not lift a damaged
1998 - 001 - 03.07.2023