Troubleshooting - Husqvarna BMS 280P Operator's Manual

7. Lightly lubricate the rubber seal on the new hydraulic
oil filter with new hydraulic oil.

Troubleshooting

Problem
The engine starts but
stops after a short
time.
To read error codes
The diagnostic tool shows the error codes with a
flashing LED. The error codes is used to identify a
problem with the product. Each error code identifies a
problem. For information about cause and solution, refer
Error codes and descriptions on page 21 .
to
The error code LED flashes multiple times. The number
of times that the error code LED will flash, shows a
number in the error code. Each error code have 4 digits.
There is a 1 second stop between each of the flashes in
an error code. There is a 3 second stop between each
error code. When the error code sequence is complete
the digits 6 and 1 (61) flashes.
1. Make sure that the ON/OFF key is put to the OFF
position.
2. Make sure that the battery voltage is more than 11
volts.
Error codes and descriptions
Error code number
0117
0122
1998 - 001 - 03.07.2023
Troubleshooting
Cause
The propane tank is almost empty.
Cause
The coolant/oil temperature sensor circuit
has a shorted connection, faulty sensor or
shorted wire.
The throttle position sensor (TPS) has an
open connection, broken wire or faulty
sensor.
8. Attach the hydraulic oil filter. Tighten by hand until
there is resistance, then tighten ¾ turn more.
9. Install the hydraulic oil drain plug when the hydraulic
oil tank is empty.
10. Fill the hydraulic tank until you can see the hydraulic
oil level is filled to the middle in the hydraulic oil level
indicator. Refer to To do a check of the hydraulic oil
level on page 19 .
11. Install the hydraulic oil cap.
12. Operate the product for a short time to ventilate the
system.
13. Do a check of the hydraulic oil level.
Solution
Fill or replace the propane tank.
3. Turn the ON/OFF key from the ON position to the
OFF position 2 times continuously.
Note:
Make sure to turn the ON/OFF key
continuously with less than 2.5 seconds between
each turn.
4. Turn the ON/OFF key to the ON position again. Let
the ON/OFF key stay in the ON position.
5. Write down the error codes while they shows.
Note:
When the error code sequence is complete
the digits 6 and 1 (61) flashes
Note:
If the error code 61 shows immediately, that
means that there are no other error codes.
Solution
Consult the service manual of the engine
and speak to Husqvarna servicing dealer.
Consult the service manual of the engine
and speak to Husqvarna servicing dealer.
21