Manually Mounting / Removing The Stylus Holders From Revo-2 Probes - Renishaw REVO User Manual

REVO-2 user's guide
www.renishaw.com
Manually mounting / removing the stylus
holders from REVO-2 probes
To manually mount the stylus holder to the REVO-2 probe:
1. Align the front sides of the probe and stylus with each other (look at the "Renishaw" engraving on the side of probe or alignment marks as
applicable).
2. Carefully offer up the stylus holder to the probe, allowing the magnetic attraction to gently make the kinematic joint.
3. Gently attempt to rotate the stylus holder to ensure correct location.
To manually remove the stylus holder from the REVO-2 probe:
1. Securely hold the stylus holder.
2. Gently tilt the stylus holder to break the kinematic joint and separate.
Issued 06 2023
32