Electrical Connections - Sanyo ECD-T1820 Operating Instructions Manual

ELECTRICAL CONNECTIONS

CAUTION
• DO NOT connect any speaker wires to the metal body or chassis of the vehicle.
• DO NOT connect the speaker common (-) wires to each other.
• Connect each speaker wire directly to each speaker terminal.
• All speaker common (-) wires must remain floating.
1
Antenna socket
Insert the plug from the antenna installed in your vehicle into this socket. (If your vehicle has a dual
•
antenna system, a dual antenna to single antenna cable adaptor may be required.)
2
+12V Constant Power Supply (Yellow)
Connect this wire to the +12V power terminal which receives power continuously.
•
Connect to location drawing 10 A amperage or more.
•
3
+12V Accessory/Switched (Red)
Connect this wire to the terminal which receives power while the ignition switch is at ON or
•
ACCESSORY position.
If the ignition switch does not have an ACC position, connect this wire to a +12V
•
power terminal which receives power continuously. (Same as item 2.)
Connect to location drawing 100 mA amperage or more.
•
4
Ground wire (Black)
Connect this wire to the vehicle chassis.
•
5
Power Antenna (Blue/Red)
Connect this wire to the control terminal of a Power Antenna.
•
When not using a Power Antenna, this wire is not connected.
•
6
Amplifier Turn On (Blue/White)
Connect this wire to an external amplifier.
•
When not using an external amplifier, this wire is not connected.
•
4-speaker System
(White)
(White/Black)
(Gray)
(Gray/Black)
(Green)
(Green/Black)
(Violet)
(Violet/Black)
2. +12V Constant Power Supply (Yellow)
3. +12V Accessory/Switched (Red)
4. Ground Wire (Black)
5. Power Antenna (Blue/Red)
6. Amplifier Turn On (Blue/White)
1. ANTENNA SOCKET
ANTENNA
PLUG
Front Left
Speaker
Front Right
Speaker
Rear Left
Speaker
Rear Right
Speaker
-22-