With cd changer control full panel detachable high power fm/am stereo receiver compact disc player with cd changer controller iso mounting with removable trim ring (26 pages)
SANYO mobile audio dealer Changes or modifications not expressly approved by SANYO may void the user’s authority to operate this equipment This device complies with Part 15 of the FCC Rules Operation is subject to the...
COMPACT DISC CARE Dust, dirt, scratches or warpage can cause a deterioration in the sound, or intermittent skipping of some tracks during play This unit has been designed to play compact discs bearing identification logo shown on the left DIGITAL AUDIO No other discs can be played Fingerprints...
USING THE DETACHABLE FRONT PANEL To Detach the Front Panel 1 Press the release button (REL), then the right-hand side of the panel will be ejected 2 Remove the front panel by pulling its right-hand side outward 3 For safekeeping, store the front panel in the supplied protective case immediately...
Page 7
To Reinstall the Front Panel 1 Push the front panel into the main body A ‘click’ sound should be heard 2 Note that if the front panel fails to lock in position properly, pushing the release button may not release the panel, and the other control buttons may not function Precautions...
ELECTRICAL CONNECTIONS WIRING FOR ECD-HI340 I .II ----- 4-speaker System _ _ _ _ , _ _ _ _ _ _ P-speaker System _ _ _ _ _ (White)@& n Front Left Left (White/Black) 8 &= slack) emSpeaker Speaker (Gray) CB 8 n Front Riaht I A Riaht...
Page 9
Notes - When using a two-speaker installation, the Green, Green/Black, Violet and Violet/Black wires, which are used for a four-speaker installation, are not used Cover the ends of these wires with electrical tape to prevent them from shorting the unit or the vehicle chassis - When using a two speaker installation, set the FADER control to the center position...
LOCATION AND FUNCTION OF CONTROLS Reset 1. ON/OFF Press POWER button (1) to turn on Press POWER again to turn it off If the power is off, press BND button (12) or MOD button (13) also can turn on the unit 2.
Page 11
MONO/STEREO Press MON button (4) to select monaural or stereo (Mono reception for radio stations) You can sometimes improve reception of distant stations by selecting mono operation FACEPLATE RELEASE Press REL button (5) to detach the removable faceplate LOUDNESS Press LOU button (6) to increase bass output and display will show “LOUD”...
Page 12
14. LIQUID CRYSTAL DISPLAY The LCD (14) can show the current state of the unit 15 & 16. SELECT STATIONS Press and release a TUNE/SKIPd - button (15) or TUNE/SKIP + /B button (16) immediately to move radio frequency number down or up on step Press and hold a TUNE/SKIPd - button (15) or TUNE/SKIP...
..15A lnstallationsize(WxHxD) ---___----- ____ ---- __.. --- ___... -__ 200x785x142mm IMPORTANT INFORMATION Because its products are subject to continuous improvement, SANYO reserves the right to modify product designs and specifications without notice and without incurring any obligation...
~~~ 1 TROUBLE SHOOTING If any of the problems Before going through the check list, check wiring connection persist after check list has been made, consult your nearest service dealer Symptom Cause Solution If the power supply is properly No power The car ignition is not on connected...
SANYO MOBILE AUDIO MODEL ECD-H1340 LIMITED WARRANTY OBLIGATIONS In order to obtain warranty service, the product must be delivered to and picked up from an Authorized Sanyo Factory Service Center at the user’s expense, unless specifically stated otherwise in this...
Page 16
21605 Plummer Street Chatsworth, CA91 311 ECD-HI340 Issue Number Printed in Hong Kong 88.CO602-03...