Electrical Connections - Sanyo FXD-780GD Operating Instructions Manual

ELECTRICAL CONNECTIONS

WIRING
CAUTION
• DO NOT connect any speaker wires to the metal body or chassis of the vehicle.
• DO NOT connect the speaker common (–) wires to each other.
• Connect each speaker wire directly to each speaker terminal.
• All speaker common (–) wires must remain floating.
1
Antenna socket
• Insert the plug from the antenna installed in your vehicle into this socket. (If your vehicle has a dual
antenna system, a dual antenna to single antenna cable adaptor may be required.)
2
+ 12V Constant Power Supply (Yellow)
• Connect this wire to the +12V power terminal which receives power continuously.
3
+12V Accessory/Switched (Red)
• Connect this wire to the terminal which receives power while the ignition switch is ON or in the ACCES-
SORY position.
• If the ignition switch does not have on ACC position, connect this wire to a +12V power terminal which
receives power continuously. (Same as item 2.)
4
Ground wire (Black)
• Connect this wire to the vehicle chassis.
5
Power Antenna/Amplifier Turn On (Blue)
• Connect this wire to the control terminal of a Power Antenna or an external amplifier.
• When not using a Power Antenna or an external amplifier, this wire is not connected.
ANTENNA SOCKET
ANTENNA PLUG
4-speaker System
(White)
Front Left
(White/Black)
Speaker
(Gray)
Front Right
(Gray/Black)
Speaker
(Green)
Rear Left
(Green/Black)
Speaker
(Violet
Rear Right
(Violet/Black)
Speaker
+12V Constant Power Supply (Yellow)
+12V Accessory/Switched (Red)
Ground Wire (Black)
Power Antenna/Amplifier Turn On (Blue)
In the case of a 2-speaker system,
tape the ends of unconnected
terminals to prevent short circuit
2-speaker System
(White)
(White/Black)
(Gray)
(Gray/Black)
(Green)
(Green/Black)
(Violet
(Violet/Black)
17
Left
Speaker
Right
Speaker
Do Not
Connect
Do Not
Connect