Siemens SIPROTEC 7UM62 Manual page 514

Technical Data
4.36 User-defined Functiones (CFC)
Device-specific Limits
Maximum number of synchronous
changes of chart inputs per task level
Maximum number of chart outputs per
task level
Additional Limits
Task Level
MW_BEARB
PLC1_BEARB
PLC_BEARB
SFS_BEARB
1)
When the limit is exceeded, an error message is output by the device. Consequently, the device starts mon-
itoring. The red ERROR-LED lights up.
2)
The following condition applies for the maximum number of timers: (2 · number of TIMER + number of
TIMER_SHORT) < 30. TIMER and TIMER_SHORT hence share the available timer resources within the
frame of this inequation. The limit does not apply to the LONG_TIMER.
3)
The time values for the blocks TIMER and TIMER_SHORT must not be selected shorter than the time res-
olution of the device, as the blocks will not then start with the starting pulse.
Maximum Number of TICKS in the Task Levels
MW_BEARB (Measured Value Processing)
PLC1_BEARB (Slow PLC Processing)
PLC_BEARB (Fast PLC Processing)
SFS_BEARB (Interlocking)
1)
When the sum of TICKS of all blocks exceeds the limits before-mentioned, an error message is output by
CFC.
514
Description
Additional limits
2) 3)
TIMER
Task Level
Limit
165 When the limit is exceeded, an error message is output by
the device. Consequently, the device starts monitoring. The
red ERROR-LED lights up.
150
1)
for the following CFC blocks:
Maximum Number of Modules in the Task Levels
TIMER_SHORT
—
15
—
Comments
2) 3)
—
30
—
Limit in TICKS
SIPROTEC, 7UM62, Manual
C53000-G1176-C149-7, Release date 03.2010
1)
10000
2000
400
10000