Kyocera PE-MF2 Service Manual page 145

Agitator Motor Error
The agitator motor error is detected twice for 10 msec during the initialization at power-on or
after the cover is closed.
480
• Disconnected or defective harness
• Defective agitator motor
1. Check or replace the harness.
2. Replace the agitator motor.
ITB (Image Transfer Belt) Unit Set Error
The TM sensor does not detect the reflection from the ITB.
• No ITB unit in the machine
490
• Dirty TM sensor
1. Check the installation of the ITB unit.
2. Clean the TM sensor.
SC 5xx (Motor and Fusing Error)
Transport/Fusing Motor Error
The LOCK signal error is detected when the EGB monitors the transport/fusing motor state. (This
monitoring is done immediately after power-on, when the motor starts rotating, and immediately
after the motor stops.)
500
• Disconnected or defective motor harness.
• Motor slips due to excessive load
1. Check the harness from the transport/fusing motor. Replace it if necessary.
Service Call Conditions
3
27