Kyocera PE-MF2 Service Manual page 105

7. For a USB connection, click [F/W Update (USB)] [A]. For a network connection, enter the machine's
IP address in [MFP IP] [B], and then click [F/W Update (NET)] [C].
8. Check the control panel display for messages and the update's current percentage of completion.
• The Update may take a while to complete. Do not turn off the power during the update.
• Turn off the power only when the machine beeps and "Firmware Update Done Please Reboot"
appears on the control panel display.
9. Wait until the machine beeps once and "Firmware Update Done Please Reboot" appears on the
control panel display.
• Click [Close] to the update tool.
10. Turn off the power, and turn it back on.
• After you turn the power back on, "Initializing" appears on the control panel display.
11. Wait until the initial screen appears on the control panel display.
• If the initial screen does not appear after more than one minute, the update is not complete. In
this case, see "Updating Failure".
12. Repeat Steps 3 to 5 to print the configuration page again.
Take note of the new firmware version (shown under "Firmware Version" on the configuration page).
13. Reconnect the telephone line cable to the machine.
Firmware Updating
5
103