Replacing A Gobo From The Rotating Gobowheel - SHOWTEC Indigo 6500 Manual

Replacing a Gobo from the rotating Gobowheel

1. Disconnect mains power supply and set the switch to OFF.
2. Make sure that the gobo you want to insert has the same size. For the right size, see below.
Gobo Size
3. Loosen the 4 screws on the back of the housing, where the 2 fans are located.
4. Gently tilt the head so the small metal housing will slide out more easy.
5. Turn the gobo wheel, with the gobo you want to remove, to the upside.
6. Gently lift up the gobo holder
7. Very carefully take the gobo out of the gobo holder with a pair of pliers.
8. Place the new gobo in the gobo holder. Carefully put the pinchcock back, gently press the pinchcock
a little bit together. Possibly use a pair of pliers to press the pinchcock a little bit together.
9. Put the gobo holder back under the pressing snap and push it back.
10. Replace the maintenance caps and fasten all screws.
Fig. 7
Fig. 8
10º and then gently pull out the gobo from its position.
26
Fig. 9