Appliance Connections; Fitting On A Power Supply Cable - EAS Electric EMV48DTN Instruction Manual

45cm multifunction oven
Table of Contents

Advertisement

Available languages

Available languages

Note: the installation and handling, please do not use the handle for stress point
The panels of the adjacent cabinets must be made of heat-resistant material. In
particular, cabinets with a veneer exterior must be assembled with glues which
can withstand temperatures of up to 100ºC. In compliance with current safety
standards, contact with the electrical parts of the oven must not be possible
once it has been installed. All parts, which ensure the safe operation of the
appliance, must be removable only with the aid of a tool.

11. APPLIANCE CONNECTIONS

11.1 Fitting on a Power Supply Cable

Those ovens equipped with a three-pole power supply cable are designed to
operate with an alternating current. The wire for earthing the appliance is yellow-
green in color.
Opening the terminal board:
Using a screwdriver, prize the bolt on the side tabs of the Terminal board cover;
Unscrew the bolt, pull open the cover of the terminal board.
To install the cable, proceed as follows:
Remove the wire clamp screw and the three contact screws L-N -
Fasten the wires beneath the screw heads using the following color scheme :Blue
(N) Brown (L) Yellow-Green (
Fasten the supply cable in place with the clamp and close the cover of the
terminal board.
The AC power supply should be 220-240 v, 50 Hz, the minimum 16 A distribution
circuit fuse, or at least 16 a distribution circuit breaker.
11.2 Connecting the supply cable to the mains
Install a standardized plug corresponding to the load indicated on the data plate.
When connecting the cable directly to the mains, install an Omni polar circuit
breaker with a minimum contact opening of 3 mm between the appliance and
the mains. The Omni polar circuit breaker should be sized according to the load
and should comply with current regulations (the earth wire should not be
interrupted by the circuit breaker).
The supply cable should be positioned so that it does not reach a temperature of
more than 50ºC with respect to the room temperature, anywhere along its
length, or protected by insulation sleeping having an appropriate rating.
)
12
V.2

Advertisement

Table of Contents
loading

Table of Contents