Installation; Before The Installation; Installation Of Built-In Ovens - EAS Electric EMV48DTN Instruction Manual

4) Pull the door towards you, pulling it out of its seat;
Reassemble the door by following the above procedures backwards.
Replacing the oven Lamp
1) Disconnect the oven from the power supply by means of the omnipolar switch used
to connect the appliance to the electrical mains; or unplug the appliance if the plug is
accessible;
2) Remove the glass cover of the lamp-holder ;
3) Remove the lamp and replace with a lamp resistant to high temperatures (300ºC) with
the following characteristic.
 Voltage: 220-240V
 Wattage: 25W
 Type: E14
4) Replace the glass cover and reconnect the oven to the mains
power supply.

10. INSTALLATION

10.1 Before the Installation

Please check the products shell and make sure that there is no trace caused by striking or
heavy load. Check that the oven door is level, and you can close door flexibly.
Parameter on the nameplate is in compliance with the relevant regulations. When the
oven is working in a abnormal way, it must be stopped and unplug the power supply until
it has been repaired by a competent person from local agency or factory authorized
service. It is hazardous for anyone other than a competent person to carry out any service
or repair operation.
10.2 Installation
Only a qualified person in compliance with the instructions provided must install the
appliance. Manufacturer declines all responsibility for improper installation, which may
harm persons and animals and damage property.
Important:
- The power supply to the appliance must be cut off before any adjustments or mainte-
nance work is done on it;
- Air duct is supposed to use in Ventilation.
- The AC power supply should be 220-240 v, 50/60 Hz, the minimum 16 A distribution
circuit fuse, or at least 16 a distribution circuit breaker

10.3 Installation of Built-in Ovens

If we put the oven into cabinet, the material cabinet should be insulated, and the clearance
between the edge of the cabinet and the oven should be over 500mm for ventilation.
10
V.2