Pluggable Transceivers Supported On Jrr200 Route Reflector; Sfp+ Direct Attach Copper Cables For Jrr200 Route Reflector - Juniper JRR200 Hardware Manual

SFP+ Direct Attach Copper Cables for JRR200 Route Reflector | 27

Pluggable Transceivers Supported on JRR200 Route Reflector

The ports on the JRR200 Route Reflector supports SFP+ transceivers. You can find the list of
transceivers supported on JRR200 route reflector and information about those transceivers at the
Hardware Compatibility Tool.
NOTE: We recommend that you use only optical transceivers and optical connectors purchased
from Juniper Networks with your Juniper Networks device.
CAUTION: The Juniper Networks Technical Assistance Center (JTAC) provides
complete support for Juniper-supplied optical modules and cables. However, JTAC does
not provide support for third-party optical modules and cables that are not qualified or
supplied by Juniper Networks. If you face a problem running a Juniper device that uses
third-party optical modules or cables, JTAC may help you diagnose host-related issues if
the observed issue is not, in the opinion of JTAC, related to the use of the third-party
optical modules or cables. Your JTAC engineer will likely request that you check the
third-party optical module or cable and, if required, replace it with an equivalent
Juniper-qualified component.
Use of third-party optical modules with high-power consumption (for example,
coherent ZR or ZR+) can potentially cause thermal damage to or reduce the lifespan of
the host equipment. Any damage to the host equipment due to the use of third-party
optical modules or cables is the users' responsibility. Juniper Networks will accept no
liability for any damage caused due to such use.
SFP+ Direct Attach Copper Cables for JRR200 Route Reflector
Small form-factor pluggable plus transceiver (SFP+) direct attach copper (DAC) cables are suitable for
short distances of up to 23 ft (7 m), making them ideal for highly cost-effective networking connectivity
within a rack and between adjacent racks. The JRR200 Route Reflector supports the following 1 m and 3
m long DAC cables:
• SRX-SFP-10GE-DAC-1M
27
The