Homematic IP HmIP-Set-5 Installation Instructions And Operating Manual page 47

Access Point first.
To add the blind actuator, please proceed as follows:
• Open the Homematic IP app on your smart-
phone.
• Select the menu item "Add device".
• After installation, the pairing mode of the device
remains activated for 3 minutes.
If the time has exceeded, you can manually re-
start the pairing mode for another 3 minutes by
removing the rocker and pressing the system
button (A) shortly (see figure 9).
• Your device will automatically appear in the
Homematic IP app.
• To confirm, please enter the last four digits of the
device number (SGTIN) in your app or scan the
QR code. Therefore, please see the sticker sup-
plied or attached to the device.
• Please wait until pairing is completed.
If pairing was successful, the LED (A) lights up
•
green. The device is now ready for use.
• If the LED lights up red, please try again.
• Complete the setup of your blind actuator by fol-
lowing the instructions in the app.
• In the app, give the device a name and allocate
it to a room.
Start-up
47