Using Mount Kits
The 570EX Series access point can be installed on a wall or attached to a pole by using mount kits:
Table 4
Part Number
JW052A
JW053A
JW054A
JW055A
The 570EX Series access point does not ship with any mount kits. These mount kits are available as accessories
and must be ordered separately.
For installation instructions on AP-270-MNT-V1, AP-270-MNT-V2, AP-270-MNT-H1 and AP-270-MNT-H2 mount
kit, please refer to the AP-270-MNT-V1 Installation Guide, AP-270-MNT-V2 Installation Guide, AP-270-MNT-H1
Installation Guide and AP-270-MNT-H2 Installation Guide respectively.
!
This 570EX Series access point is intended for installation in a RESTRICTED ACCESS LOCATION attached to a
pole or installed on a wall. Installers should disconnect power before working with or near the access point.
Grounding the Access Point
The grounding must be completed before powering up the access point. The grounding wire should be #8 AWG.
1. Peel the cover of one end of the grounding wire and place the bare grounding wire into the grounding lug
(included in the package), and press firmly with the crimping pliers.
2. Fasten the grounding lug to the grounding hole on the access point with the M4x6 screw (included in the
package). We recommend to torque the M4x6 screw to 1.5 N.m.
Connecting the Ethernet Cable
To connect the Ethernet cable to the access point, perform the following steps.
!
Failure to use the included Ethernet cable glands can lead to connectivity and POE issues.
The cable is not included and must be purchased separately. Purchase a suitable UV-resistant, outdoor rated,
CAT 5E or better RJ45 cable for use with the access point.
8
Applicable Mount Kits for 570EX Series Access Point
Description
AP-270-MNT-V1 long mount kit for wall and vertical pole mounting, 300 mm from
vertical mounting asset.
AP-270-MNT-V2 short mount kit for wall and vertical pole mounting, 75 mm from
vertical mounting asset.
AP-270-MNT-H1 mount kit for hanging from inclined or horizontal structure.
AP-270-MNT-H2 flush mount kit for wall and ceiling mounting.
Aruba 570EX Series Hazardous Location Access Points
| Installation Guide