Table of Contents
Advertisement
LED
The 570EX Series access point is equipped with one LED that indicates the system status of the access point.
Table 1
LED
System LED
Table 2
LED
System LED
Ethernet Ports
The Aruba 570EX Series access points are equipped with two Ethernet ports (E0 and E1):
E0 port: 100/1000/2500Base-T auto-sensing MDI/MDX wired RJ45 network connectivity port
E1 port: 100/1000Base-T auto-sensing MDI/MDX wired RJ45 network connectivity port
Power
Both E0 and E1 ports support PoE-in, allowing the AP to draw power from an 802.3at/802.3bt PoE power source.
When the AP is powered by both E0 and E1 ports simultaneously, the AP can be configured by management
software to source PoE power from either port, or to combine power from both ports.
The 570EX Series access points support the Intelligent Power Monitoring (IPM) feature, to report AP power
consumption and enable intelligent management of power-save capabilities.
Table 3
lists operational restrictions when the AP is powered by different power options.
Table 3 Power Options and Operational Restrictions
Power Source
1 x 802.3bt PoE
2 x 802.3at PoE
1 x 802.3at PoE
1 x 802.3at PoE
1 x 802.3af PoE
Aruba 570EX Series Hazardous Location Access Points
570EX Series LED Meanings during Boot Up
Color/State
Off
Red
Green - Flashing
Green - Steady
Green - Yellow, 6 seconds
period
570EX Series LED Meanings during Operation
Color/State
Solid Red
One blink off every 3
seconds
Two quick blink off 0.5
seconds apart cycled every
3 seconds
| Installation Guide
Meaning
No power to AP
Initial power-up
AP booting, not ready
AP ready and Gigabit Ethernet connected. The LED turns off after
1200 seconds
AP ready and 10/100Mbps Ethernet link established. The LED
turns off after 1200 seconds
Meaning
General fault - Immediate attention required
Radio 0 fault (5GHz)
Radio 1 fault (2.4GHz)
IPM
Restrictions
n/a
No restrictions, all capabilities available.
n/a
No restrictions, all capabilities available.
enabled
AP starts up in unrestricted mode, but may dynamically
apply restrictions depending on the PoE budget and actual
power.
disabled
Second (other) Ethernet port disabled.
n/a
AP does not start up, red system LED.
5
Advertisement
Table of Contents
