Table of Contents
Advertisement
Replacing parts,
Electronics
Follow these steps to locate and exchange electronic parts from the inside service en-
trance
Electronics
replacement
illustration
continued
Step
1
Disconnect power, and remove all plugs connected to the connection panel
2
Remove the 10 pcs. TX 20 screws and remove the cover plate pos.A
3
Remove the 2 pcs. TX 20 screws from the connection place Pos B and gently
pull the plate out 5-10 cm, and disconnect the temperature dial plug from
the controller PCB.
4
Locate any possible fault according the troubleshooting section in this manu-
al, and exchange defective modules.
Parts location:
1:CC3 controller PCB
2:DC filter PCB
3:Capacitor
4:Compressor drive PCB
5
Re-assemble the unit in the opposite order
Action
27
Advertisement
Table of Contents
