Table of Contents
Advertisement
Section 1 - Getting to Know Your Power Package
Keep the Lanyard Stop Switch and Lanyard Cord in Good Operating Condition
Before each use, ensure that the lanyard stop switch works properly. Start the engine, and then stop it by pulling the lanyard
cord. If the engine does not stop, have the switch repaired before operating the boat.
Before each use, inspect the lanyard cord to ensure that it is in good working condition and that there are no breaks, cuts, or
wear to the cord. Check that the clips on the ends of the cord are in good condition. Replace any damaged or worn lanyard
cords.
Instrumentation
VesselView
There are several VesselView products available. VesselView will display all engine information, fault codes, vessel
information, basic navigation data, and system information. When an operating system error or failure occurs, VesselView
displays an alarm message.
VesselView may also be connected to other vessel systems such as GPS, generators, and chartplotters. This vessel
integration allows the operator to monitor and control a wide range of vessel systems from a single display.
Refer to the VesselView operator's manual for more information.
SmartCraft Digital Instruments
The SmartCraft instrument package augments the VesselView display. The instrument package may include:
•
Tachometer
•
Speedometer
•
Engine coolant temperature
•
Engine oil pressure
•
Battery voltage
•
Fuel consumption
Page 6
VesselView 7
56038
90-8M0113859
DECEMBER 2015
eng
Advertisement
Table of Contents
