Engine Oil; Checking; Oil Level-Overfilled - Mercury 4.3 MPI SeaCore Operation & Maintenance Manual

Table of Contents

Advertisement

Engine Oil

Checking

Discharge of oil, coolant, or other engine/drive fluids into the environment is restricted by law. Use caution not to spill oil,
coolant, or other fluids into the environment when using or servicing your boat. Be aware of the local restrictions governing
the disposal or recycling of waste, and contain and dispose of fluids as required.
1.
With the engine warm but not running, wait five minutes to allow the oil to drain into the oil pan.
2.
Remove the dipstick, wipe it clean, and install it fully into the dipstick tube. Wait 60 seconds to allow trapped air to vent.
NOTE: On the 5.0 MPI and SeaCore ECT models, ensure that the dipstick is installed with oil level indication marks facing
the rear of the engine (flywheel end).
3.
Remove the dipstick and observe the oil level. Oil level must be between "FULL" or "OK" range and "ADD." Install dipstick
into dipstick tube. If the oil level is low, refer to Filling.
4.
On 4.3 models, the oil level must be no higher than the maximum oil level mark and no lower that the minimum oil level
mark.
Oil Level—Overfilled
IMPORTANT: Do not overfill the engine with oil. An overfilled crankcase can cause a fluctuation or drop in oil pressure and
rocker arm clatter, and result in a loss of engine performance.
An overfilled crankcase (oil level too high) can cause a fluctuation or drop in oil pressure, and rocker arm clatter. This condition
results in the engine crankshaft splashing and agitating the oil, causing it to foam (become aerated). The aerated oil causes the
hydraulic valve lifters to bleed down. This results in rocker arm clatter and loss of engine performance.
Care must be taken when checking the engine oil level. The oil level must be maintained within the full maximum and the add
minimum mark on the dipstick. To avoid getting a false reading, adhere to the following procedures.
90-8M0113859
DECEMBER 2015
eng
NOTICE
33200
5.0 ECT
a
b
c
53993
Section 4 - Maintenance
4.3 ECT
a -
Engine oil dipstick handle
b -
Maximum oil level mark
c -
Minimum oil level mark
Page 47

Advertisement

Table of Contents
loading

This manual is also suitable for:

5.0 mpi seacore

Table of Contents