Rear Panel Connections - Redback A 4565B Operating Manual

Redback® A 4565B Evacuation Controller

1.5 REAR PANEL CONNECTIONS

The layout of the A 4565B rear panel is shown below in figure 1.5 .
IMPORTANT NOTE
Ensure power is switched off when
24V DC 24V DC adjusting DIP switches. New
settings will be effective when
IN IN
power is switched back on.
DIP Switches
Micro SD Card
1 2 3 4 5 6 7 8
- +
1 2 3 4 5 6 7 8 (16GB Maximum)
27 26 25 24
1 Fire Contact
These contacts are for remote triggering of the Fire tone. Requires a closing contact to operate.
2 Evac Contact
These contacts are for remote triggering of the Evacuation tone. These could be triggered by a fire indicator
board, break glass alarm etc or by connecting the A 2078B or A 2081 remote plates to these contacts (see section
3.1 for more details). Requires a closing contact to operate.
3 Alert Contact
These contacts are for remote triggering of the Alert tone. These could be triggered by a fire indicator board,
break glass alarm etc or by connecting the A 2078B or A 2081 remote plates to these contacts (see section 3.1 for
more details). Requires a closing contact to operate.
4 Bell Contact
These contacts are for remote triggering of the Bell tone. These could be triggered by a remote switch or by
connecting the A 2081 remote plate to these contacts (see section 3.1 for more details). Requires a closing con
tact to operate.
5 Cancel Contact
These contacts are for remote triggering of the cancel function. These could be triggered by a remote switch,
or by connecting the A 2081 remote plate to these contacts (see section 3.3 for more details). Requires a closing
contact to operate.
6 Fire 24V Out
This is a 24V DC output which is activated when the Fire contact is triggered. The terminals provided can be used
for "Normal" or "Failsafe" modes (see section 2.5 for more details).
7 Evac 24V Out
This is a 24V DC output which is activated when the Evac tone is activated. The terminals provided can be used
for "Normal" or "Failsafe" modes (see section 2.5 for more details).
8 Alert 24V Out
This is a 24V DC output which is activated when the Alert tone is activated. The terminals provided can be used
for "Normal" or "Failsafe" modes (see section 2.5 for more details).
9 Bell 24V Out
This is a 24V DC output which is activated when the Bell tone is activated. The terminals provided can be used for
"Normal" or "Failsafe" modes (see section 2.5 for more details).
10 Common 24V Out
This is a combined 24V DC output which is activated when any of the Bell, Alert or Evac tones are activated. The
terminals provided can be used for "Normal" or "Failsafe" modes (see section 2.5 for more details).
6 Redback® Proudly Made In Australia
1 2 3 4 5 6 7 8 9
Fire Evac Alert Bell
24V Out 24V Out 24V Out 24V Out
Contacts
All switched outputs limited to 120mA maximum current draw
10
1 2
Common
24V Out
PA Mic
3 To Wall Plates 4 To Paging
Vol
(Maximum 500mA per output) Console
22 21 20
Fig 1.5
11 12
L L
R R
Evac Bell Fire V/Over Chime Audio BGM BGM
Vol Vol Vol Vol Vol In
Out Volume
19 18 17 16 15 14
www.redbackaudio.com.au
13
Made in Australia by
Altronic Distributors Pty Ltd
L
R
Audio
www.redbackaudio.com.au
In