Connecting The Pe Cable - Goodwe ETC Series User Manual

User Manual V1.0-2023-05-20
The door of the wiring compartment is not pre-drilled for the wire inlet hole. A hobby knife is
required to cut a hole according to the outer diameter of the cable. Make sure that the size
of the inlet hole is appropriate so that the gap is not too large, which could lead to insects,
rodents or other animals entering the equipment and causing damage to the equipment.

6.4 Connecting the PE cable

• The PE cable on the top wiring board cannot replace the PE cable connected to the AC
output port. Make sure that both of the two PE cables are securely connected.
• Make sure that all the grounding points on the top wiring board are equipotential
connected when there are multiple inverters.
• To improve the corrosion resistance of the terminal, you are recommended to apply silica
gel or paint on the ground terminal after installing the PE cable.
• The PE cable should be prepared by the customer.
NOTICE
WARNING
29
06 Electrical Connection