Installing The Fork Protector; Removing The Lower Triple Clamp - Husqvarna TC 85 2023 Owner's Manual

11.8

Installing the fork protector

11.9

Removing the lower triple clamp

SERVICE WORK ON THE CHASSIS 11
–
Position the fork protector on the right fork leg. Mount and
tighten screws
Guideline
Remaining screws,
chassis
–
Position the fork protector on the left fork leg. Mount and
tighten screws
Guideline
A00141-10
Remaining screws,
chassis
–
Position the brake line and clamp. Mount and tighten
3
screws .
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
–
Remove the start number plate. (
–
Remove front fender. (
–
Remove the handlebar cushion.
Main work
–
Pull fuel tank breather
–
Loosen screw
clamp with the handlebar in an upward direction, and hang it
to the side.
Info
Cover the components to protect them against dam-
age.
S03429-10
Do not kink the cables and lines.
–
Remove protective ring
–
Take off the lower triple clamp with the steering stem in a
downward direction.
–
Remove the upper steering head bearing.
S03430-10
1
.
M6 10 Nm (7.4 lbf ft)
2
.
M6 10 Nm (7.4 lbf ft)
p. 45)
( p. 86)
( p. 46)
p. 54)
p. 55)
1
out of the steering stem.
2 3
. Remove nut , pull off the upper triple
4
.
49