complete the installation.
2.2 Cabling
1.
When using a PoE Switch or PoE Injector, connect the camera using an
Ethernet cable for both data and power.
2.
When not using PoE Switch or PoE Injector, connect the camera to the
switch using an Ethernet cable for data transmission and use a power
adapter to power the camera.
DC12V, PoE (IEEE 802.3af class 3).
Adapter not Included.
3.
Use the diagram below to connect power, network and audio to the camera.
2.3 Managing the SD Card
1.
To install the camera's SD Card, locate the SD card slot at the base of the
camera module by loosening the lock screw at the base of the camera.
2.
Insert class 10 SD/SDHC/SDXC card into
the SD card slot by pressing the SD card
until clicks.
3.
To remove the SD card, press the card
inward until it clicks to release from the
card slot then pull out from the slot.
Power requirements
Power consumption
<7W
3