Snmp; 802.1X; Rtsp - Digital Watchdog MEGApix DWC-MT95Wi36TW User Manual

3. Enter the username, password , d omain you apply for in the DDNS
configuration interface.
4. Click the "Save" button to save the settings.

5.5.4 SNMP

To get camera status, parameters and alarm information and remotely manage
the camera, the SNMP function can be used. Before using SNMP, please install an
SNMP management tool and set the parameters of the SNMP, such as SNMP port,
trap address.
1. Go to Config > Network > SNMP.

5.5.5 802.1x

If it is enabled, the camera's data can be protected. When the camera is
connected to the network protected by the IEE802.1x, user authentication is
needed.
To use this function, the camera shall be connected to a switch supporting 802.1x
protocol. The switch can be reckoned as an authentication system to find the
device in a local network. If the camera connected to the network interface of the
switch has passed the authentication of the switch, it can be accessed via the
local network.
Protocol type and EAPOL version: Please use the default settings.
Username and password: The username and password must be the same as the
username and password applied for and registered in the authentication server.

5.5.6 RTSP

Go to Config > Network > RTSP.
33