Sound - Loewe Reference lD 55 User Manual

Reference ID 40-55
User guide
System settings

Sound

Sound
Calling the sound settings
The selectable menu items depend on the selected station and the
connected sound components (e.g., sound projector).
HOME: Call Home view.
Mark System settings,
OK call System settings.
Mark Sound,
go to next column.
Sound Sound mode Sound mode
Sound Sound
adjustment adjustment
Loudness Loudness
Souond pic-
Volume ad- Volume ad-
justment justment
more ...
Select sound function,
proceed to next column.
Explanations of the sound settings:
Sound mode Select the number of speakers you want to hear. The se-
lection depends on the connected sound components
and on the transmitted audio signal.
If the number of speakers appears in brackets,
the sound of missing speakers is transmitted by
the existing speakers (virtually).
Optimum The momentarily reproduced audio signal is output
with the ideal number of speakers.
Play centre sound or mono (left/right).
Play front sound (L/R stereo).
Play front and centre sound.
Play front and surround sound.
Play front, surround and centre sound.
HiFi/AV Play via an external HiFi amplifier. Selection is only
amplifier possible if an amplifier has been selected in the
sound components wizard.
Dolby PLII Here you can make Dolby Pro Logic II sound settings
mode for movie and music.
Menu item only appears with certain sound mode
settings.
Sound Here, you can adapt preset sound characteristics
adjustment of the respective broadcast. Selectable are, e.g.,
Speech, Classical, Pop, Custom music and Film
soundtracks. For personal music and film sound you
can do the settings for pitch and bass sound (high
and low frequencies).
Possible sound formats depend on the number of channels
available in the received audio signal. If more audio
channels are supplied than the number of speakers available
then you can create a pseudo mode by selecting the speaker
number which is contained within brackets. If you select
"optimal" then the number of speaker used will automatically,
if possible, match the number of audio channels received, this
normally gives the best sound quality. If a sub woofer is
connected it is always active unless you select mono mode i.e
a single speaker.
5 = playback of front, surround and centre sound
4 = playback of front and surround sound
3 = playback of front and centre sound
2 = playback of front sound
1 = playback of external centre sound or mono (left/right)
Amplifier = playback via HiFi/AV amplifier
Explanations of the sound settings (continued):
Audio Set the volume of the audio commentary to be
commentary relative to the volume of the programme being
volume transmitted.
Should negative values result (those in the area of
-50... -1), the audio commentary is quieter than the
programme sound. Should positive values result
(those in the area of +1... +50), the audio commen-
tary is louder than the programme sound. If the
value 0 results, then the audio commentary is at the
exactly the same volume as the programme sound.
The menu item only appears if audio commentary
is activated (see chapter System settings, sec-
tion Control – DVB settings) and is offered by
the current station.
Additionally, the Loudspeaker sound or Head-
phone sound must be set to normal + audio
commentary must be switched on (see next page).
Loudness Proper boost of bass and treble tones at low volume.
Sound If the sound and picture are not precisely in sync,
picture you may correct this here. Move the mark on the
synchronisa- bar downwards, slowing down the sound compared
tion with the picture. Move the mark upwards, speeding
it up compared with the picture. Time adjustment
of the sound occurs in steps of 10 ms in each case.
only available for DVB stations.
Volume The volume can differ according to the individual
adjustment stations. If the sound is too loud or too quiet in rela-
tion to other stations, adjust the volume. When the
menu is open, you can select the stations one after
another with P+/P– and adjust every single station
conveniently.
more ... call with OK (see next page).
87