Loewe Reference lD 55 User Manual page 115

Reference ID 40-55
User guide
System settings
Multimedia / Network
Configuration of the built-in LAN adaptor
The network wizard was called via the network ac-
cess setting On, wired only.
IP configuration
Select type of IP configuration.
automatic: Automatic configuration of the IP
address via DHCP server or via multiple
protocols according to UPnP specifica-
tion (including DHCP).
OK proceed to network status (see below).
manual: Enter your fixed static IP addresses
manually (see below).
OK proceed to Manual IP configuration.
Manual IP configuration
If manual has been selected under IP configuration:
Enter IP, Subnet mask, Gateway and DNS server
addresses in succession with the numerical keys
on the remote control.
Manual IP configuration
Please specify the static IP address of the network adapter.
... Netzworking
IP address
Subnet mask
Gateway
DNS server 1
DNS server 2
Back with
proceed to network status.
Network status
You see the current network status again.
BACK: End of wizard.
.
192.168.000.123
255.255.255.000
192.168.000.100
192.168.000.010
192.168.001.010
Proceed with
Configuration of the built-in WLAN bridge adaptor
The network wizard was called via the network
access setting On, wireless only or Wireless +
bridge function.
Search for Access points
The TV set now searches for wireless routers.
BACK: Stop search.
Access point selection
After the end of the search:
Select required access point from the options
found.
OK Proceed to entry of WLAN password.
No access point found
If the desired access point is not found:
Mark Search again,
OK repeat search for wireless routers.
Or:
Mark Enter access point manually,
OK enter manually the SSID of the desired access
point, e.g., when the SSID of the access point is
not transferred.
OK Proceed to entry of WLAN password.
WLAN password (WPA password / WEP password / WEP index)
If your wireless network is not encrypted: Proceed to
IP configuration.
Enter WLAN password.
In case of an unknown WLAN key, contact your
network administrator.
For encryption types supported, see chapter Tech-
nical data, section Media.
For WEP encryption
Select the WEP index,
OK proceed to IP configuration.
IP configuration
Select type of IP configuration.
For the further workflow of the network wizard
see left column under IP configuration.
Network status
At the end of the network wizard you see your current
network status again.
BACK: End of wizard.
115