Answer Armed; Answer Disarmed; Ram Ph - Bosch D9412G Program Entry Manual

D9412G/D7412G | Program Entry Guide | 2.0 9000MAIN
0101
Program this item No if it causes false
0101
seizures of the phone line or if you are not
0101
using RAM (this indicates a device using
the same frequency tone is also using the
phone line to which the control panel is
connected).
If RAM Call Back is programmed Yes, the
control panel hangs up the phone after
the RAM tone and a proper RAM
passcode is identified. It then calls the
RAM phone number.

Answer Armed

Program Record Sheet
Default: See
Selection:
1 to 15, or Blank
Blank No answer.
1 to 15 The control panel answers the phone
after the specified number of rings
when all areas are master armed.
Set the telephone ring counter to answer when all
areas are master armed. If any area in the control
panel is perimeter armed or disarmed, the Answer
Disarmed ring counter is used.
The RAM considers perimeter armed as a
disarmed state.

Answer Disarmed

Default: See Program Record Sheet
Selection:
1 to 15, or Blank
Blank No answer.
1 to 15 The control panel answers the phone
after the specified number of rings
when any area in the system is in a
perimeter armed or disarmed state.
Set telephone ring counter to answer when any area
is in a perimeter armed or disarmed state.
The RAM considers perimeter armed as a
disarmed state.
Bosch Security Systems | 10/03 | 47775E

Ram Ph

Default: Blank
Selection:
Up to 24 characters
Blank Control panel does not dial a phone
number for RAM.
This is the phone number the control panel dials to
contact RAM. The control panel dials the
programmed number on
when the following events occur:
•
Log % Full threshold is achieved.
If Log % Full was programmed with a
value (1 to 99) and a RAM phone number
is programmed, the control panel dials the
RAM phone number when the log
threshold is reached. This function is not
available in RPS. Do not program Log %
Full and RAM phone number at the same
time.
•
The control panel is contacted by RAM and
RAM Call Back is programmed Yes.
•
COMMAND 43 is initiated and the user selects
Call RAM option.
Enter up to 24 characters to define dialing
characteristics.
See Phone 1 in Section 2.1 Phone.
Remote Program Dialing Exception:
When a RAM phone number is
programmed, the user can call RAM by
pressing [COMMAND][4][3] then [NEXT]
until CONTACT RAM? displays, then press
[ENTER]. At this point, the user can press
[ENTER] when RAM VIA PHONE? is
displayed. When performing this function,
only one attempt is made to contact RAM.
EN | 33
Phone #5 RAM Ph #
( )